Talked to Holley today and they recommended using a 1/2" square bore spacer on stock 66 intake to accommodate larger goggle valve. Does anyone see an issue with this? Would this be an improvement or have a negative effect? Thanks
Yep for the choke. The tubes come right out of the intake are they just pressed in? I dont see a way to do block off plate this area is not flat. I dont want it to look like something was just rigged up. Thanks
Is it like the one below with the two tubes on the flange? And the two tubes loop down into the exhaust and back up? If so, i'd find a way to plug them. If they're the kind where they're mounted on a plate and the intake warms them with no exposure to the exhaust, like the tri power manifolds, i'd just remove everything and leave the "dip" in the intake.